LJSPECIALTIES

LJSPECIALTIESLJSPECIALTIESLJSPECIALTIES
  • Home
  • LJS Repair Sytems
    • Waterproof Coating System
    • Water/Waste Repair System
    • Crack Repair System
    • Leaking Crack Repair
  • LJS Products
    • LJS Concrete Additive
    • LJS Concrete Adhesive
    • LJS Masonry Sealer
    • LJS Masonry Hardener
  • More
    • Home
    • LJS Repair Sytems
      • Waterproof Coating System
      • Water/Waste Repair System
      • Crack Repair System
      • Leaking Crack Repair
    • LJS Products
      • LJS Concrete Additive
      • LJS Concrete Adhesive
      • LJS Masonry Sealer
      • LJS Masonry Hardener

LJSPECIALTIES

LJSPECIALTIESLJSPECIALTIESLJSPECIALTIES
  • Home
  • LJS Repair Sytems
  • LJS Products

LJS Masonry Sealer

Waterproofing compound for all Concrete and Masonry surfaces 


LJS Masonry Sealer is a clear and odorless  Consintrated Siloxane System. This is a highly concentrated, penetrating, inorganic, and organic based compound that is used for sealinng stucco, brick, block, natural stone, and most man made stone and concrete surfaces. 

Benefits

  • Deep penetrating
  • Allows treated surfaces to breathe
  • Reduces interior wall sweating
  • Low viscosity, dries without becoming sticky
  • Will no change the color of the surface
  • Creates a tight and smooth surface on masonry
  • Cost effictive with longer lasting results

Application

LJS Masory Sealer is very easy to use and there is no mixing required. Shake container thoughly before using or stir well. You may apply it to masonry with a spray, brush, roller, or just by soaking the surface. The coverage of this product will vary depending on the porosity of the substrate.  Standard guild line would be 125-150 sq ft/gallon. A two coat application is recommended for long term service.


*WARNING* - This product is a combustible material. Keep away from sparks or open flames. Ensure that adequate ventilation is used at all times. Avoid contact with skin or eyes. Wear rubber gloves and eye protection when using this product.  If it gets in eyes, flush eyes for 15 minutes with water and contact a doctor.

Technical Data / Specifications

  • Appearance: Colorless and clear
  • PH: N/A
  • Vapor Density: 4.900@ air=1
  • Odor: slight, hydrocarbon
  • Chemistry: Modified Polymethal Siloxane
  • Solvent System: Aliphatic Hydrocarbons (mineral spirits)
  • Solids Content: 94.5% 
  • VOC Content: 100%; 6.49 lbs/gal
  • Evaporation Rate: >.11

  • Vapor Pressure: 2.000 mmHg @ 68F
  • Specific Gravity: .758 @ 60F
  • % Volatile: 100
  • State: Liquid
  • Boiling Point (F): 340-400
  • Sealer Type: Silicone Siloxate water repellent 
  • Coverage: 75-150 sq/ft per gallon
  • Penetration: up to 1” or more / surface porosity
  • Packaging: 5 gallon pails
  • Color: Colorless, clear
  • Shelf Life: 24 months 

Photo Gallery

    Copyright © 2018 LJSpecialties - All Rights Reserved.

    Powered by GoDaddy Website Builder

    Announcement

    Welcome! Check out my new announcement.

    Learn more